Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
Text in Illustration
*a Skid Control Sensor Wire *b for RH
*c for LH - -
(a) Remove the skid control sensor wire .
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for RH
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S22-4 - Xa1-2 (RR+) Always Below 1 Ω
S22-3 - Xa1-1 (RR-) Always Below 1 Ω
S22-4 - S22-3 Always 10 kΩ or higher
S22-4 - S22-1 Always 10 kΩ or higher
S22-4 - S22-2 Always 10 kΩ or higher
for LH
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S22-2 - Xa2-2 (RL+) Always Below 1 Ω
S22-1 - Xa2-1 (RL-) Always Below 1 Ω
S22-2 - S22-1 Always 10 kΩ or higher
S22-2 - S22-3 Always 10 kΩ or higher
S22-2 - S22-4 Always 10 kΩ or higher
NG
REPLACE SKID CONTROL SENSOR WIRE
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *