RESULT PROCEED TO
DTCs C1415 and C1416 are not output A
DTCs C1415 and/or C1416 are output B
REPLACE BRAKE ACTUATOR ASSEMBLY
USE SIMULATION METHOD TO CHECK
4. CHECK REAR SPEED SENSOR INSTALLATION
a) Turn the ignition switch off.
(b) Check the rear speed sensor installation
There is no clearance between the sensor and the rear axle
The installation bolt is tightened properly.
Text in Illustration
INSTALL REAR SPEED SENSOR CORRECTLY
5. INSPECT REAR SPEED SENSOR TIP
(a) Remove the rear speed sensor .
(b) Check the speed sensor tip.
No scratches, oil, or foreign matter on the sensor tip.
f no damage to the speed sensor tip is found during this inspection, do not replace the speed sensor.
If there is iron powder sticking to the rotor, this will result in a malfunction, so confirm that the rotor is not
contaminated with foreign material before replacing the sensor.
Check the speed sensor signal after cleaning or replacement .