Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
Standard Resistance:
for RH
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S1-31 (FR+) - S4-2 (FR+) Always Below 1 Ω
S1-30 (FR-) - S4-1 (FR-) Always Below 1 Ω
S1-31 (FR+) or S4-2 (FR+) - Body ground Always 10 kΩ or higher
S1-30 (FR-) or S4-1 (FR- ) - Body ground Always 10 kΩ or higher
for LH
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S1-18 (FL+) - S3-2 (FL+) Always Below 1 Ω
S1-17 (FL-) - S3-1 (FL-) Always Below 1 Ω
S1-18 (FL+) or S3-2 (FL+) - Body ground Always 10 kΩ or higher
S1-17 (FL-) or S3-1 (FL-) - Body ground Always 10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
9. INSPECT BRAKE ACTUATOR ASSEMBLY (SENSOR OUTPUT)
(a) Reconnect the S1 skid control ECU (brake actuator assembly)
connector.
(b) Turn the ignition switch to ON.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
for RH
TESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
S4-2 (FR+) - Body ground Ignition switch ON 8 to 14 V
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *