Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
RESULT PROCEED TO
DTCs C1413 and C1414 are not output A
DTCs C1413 and/or C1414 are output B
**
REPLACE BRAKE ACTUATOR ASSEMBLY
A
USE SIMULATION METHOD TO CHECK
4. CHECK FRONT SPEED SENSOR INSTALLATION
(
a) Turn the ignition switch off.
(b) Check the speed sensor installation
.
OK:
There is no clearance between the sensor and the front steering
knuckle.
The installation bolt is tightened properly.
Text in Illustration
*a Normal
*b Abnormal
*c Clearance
NG
INSTALL FRONT SPEED SENSOR CORRECTLY
5. INSPECT FRONT SPEED SENSOR TIP
(a) Remove the front speed sensor .
(b) Check the speed sensor tip.
OK:
No scratches, oil, or foreign matter on the sensor tip.
NOTICE:
I
f no damage to the speed sensor tip is found during this inspection, do not replace the speed sensor.
If there is iron powder sticking to the rotor, this will result in a malfunction, so confirm that the rotor is not
contaminated with foreign material before replacing the sensor.
Check the speed sensor signal after cleaning or replacement .
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *