Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
(a) Remove the skid control sensor wire .
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for RH
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S22-4 - Xa1-2 (RR+) Always Below 1 Ω
S22-3 - Xa1-1 (RR-) Always Below 1 Ω
S22-4 - S22-3 Always 10 kΩ or higher
S22-4 - S22-1 Always 10 kΩ or higher
S22-4 - S22-2 Always 10 kΩ or higher
for LH
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S22-2 - Xa2-2 (RL+) Always Below 1 Ω
S22-1 - Xa2-1 (RL-) Always Below 1 Ω
S22-2 - S22-1 Always 10 kΩ or higher
S22-2 - S22-3 Always 10 kΩ or higher
S22-2 - S22-4 Always 10 kΩ or higher
NG
REPLACE SKID CONTROL SENSOR WIRE
5.
CHECK HARNESS AND CONNECTOR (BRAKE ACTUATOR ASSEMBLY - REAR SPEED
SENSOR)
(a) Turn the ignition switch off.
(b) Make sure that there is no looseness at the locking part and the connecting part of the connectors.
(c) Disconnect the S1 skid control ECU (brake actuator assembly) connector and the O3 and/or O4 rear
speed sensor connector.
(d) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for RH
TESTER CONNECTION CONDITION SPECIFIED CONDITION
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *