Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S1-18 (FL+) or S3-2 (FL+) - Body ground Always 10 kΩ or higher
S1-17 (FL-) or S3-1 (FL-) - Body ground Always 10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
6. INSPECT BRAKE ACTUATOR ASSEMBLY (SENSOR OUTPUT)
(a) Reconnect the S1 skid control ECU (brake actuator assembly)
connector.
(b) Turn the ignition switch to ON.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
for RH
TESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
S4-2 (FR+) - Body ground Ignition switch ON 8 to 14 V
for LH
TESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
S3-2 (FL+) - Body ground Ignition switch ON 8 to 14 V
Text in Illustration
*a
Front view of wire harness connector
(to Front Speed Sensor)
*b for RH
*c for LH
NG
REPLACE BRAKE ACTUATOR ASSEMBLY
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *