Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

3. RECONFIRM DTC
(a) Clear the DTCs .
(b) Turn the ignition switch off.
(c) Start the engine.
(d) Perform a road test.
(e) Check if the same DTC is recorded .
Result
RESULT PROCEED TO
DTCs C1405 and C1406 are not output A
DTCs C1405 and/or C1406 are output B
B
REPLACE BRAKE ACTUATOR ASSEMBLY
A
USE SIMULATION METHOD TO CHECK
4. INSPECT SKID CONTROL SENSOR WIRE
(
a) Remove the skid control sensor wire.
(b) Measure the resistance according to the value(s) in the table below.
Text in Illustration
*1 Skid Control Sensor Wire - -
*a for RH *b for LH
Standard Resistance:
for RH
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *