Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

NEXT
(a) Turn the ignition switch off.
(b) Replace the rear speed sensor .
NOTICE:
After replacing the speed sensor, perform a Test Mode (signal check) inspection sensor check .
6. RECONFIRM DTC
(
a) Clear the DTCs
.
(b) Turn the ignition switch off.
(c) Start the engine.
(d) Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.
(e) Check if the same DTC is recorded .
Result
RESULT PROCEED TO
DTCs C1403 and C1404 are not output A
DTCs C1403 and/or C1404 are output B
NOTICE:
C
heck the speed sensor signal after replacement
.
HINT:
The rear skid control rotor is incorporated into the rear axle shaft bearing.
If the rear skid control rotor needs to be replaced, replace it together with the rear axle shaft bearing.
B
REPLACE REAR AXLE SHAFT BEARING
A
END
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *