Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
OK
2. INSPECT REAR SPEED SENSOR TIP
(a) Remove the rear speed sensor .
(b) Check the speed sensor tip.
OK:
No scratches, oil, or foreign matter on the sensor tip.
NOTICE:
I
f no damage to the speed sensor tip is found during this inspection, do not replace the speed sensor.
If there is iron powder sticking to the rotor, this will result in a malfunction, so confirm that the rotor is not
contaminated with foreign material before replacing the sensor.
Check the speed sensor signal after cleaning or replacement .
NG
CLEAN OR REPLACE REAR SPEED SENSOR
3. INSPECT REAR AXLE SHAFT BEARING
(a) Remove the rear axle shaft bearing .
(b) Check the rear skid control rotor.
OK:
No scratches, oil, or foreign matter on the rotors.
NOTICE:
Check the speed sensor signal after cleaning or replacement .
HINT:
The rear skid control rotor is incorporated into the rear axle shaft bearing.
If the rear skid control rotor needs to be replaced, replace it together with the rear axle shaft bearing.
(c) Reinstall the rear axle shaft bearing.
for the rear speed sensor: .
for the rear axle shaft bearing: .
NG
CLEAN OR REPLACE REAR AXLE SHAFT BEARING
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *