Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

NEXT
5. REPLACE FRONT SPEED SENSOR
(a) Turn the ignition switch off.
(b) Replace the front speed sensor .
NOTICE:
After replacing the speed sensor, perform a Test Mode (signal check) inspection sensor check .
6. RECONFIRM DTC
(
a) Clear the DTCs
.
(b) Turn the ignition switch off.
(c) Start the engine.
(d) Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.
(e) Check if the same DTC is recorded .
Result
RESULT PROCEED TO
DTCs C1401 and C1402 are not output A
DTCs C1401 and/or C1402 are output B
NOTICE:
C
heck the speed sensor signal after replacement
.
HINT:
The front skid control rotor is incorporated into the front axle hub inner bearing.
If the front skid control rotor needs to be replaced, replace it together with the front axle hub inner
bearing.
B
REPLACE FRONT AXLE HUB INNER BEARING
A
END
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *