Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
Text in Illustration
*a
Front view of wire harness connector
(to Yaw Rate and Acceleration Sensor [Airbag Sensor Assembly])
HINT:
If troubleshooting has been carried out according to the Problem
Symptoms Table, refer back to the table and proceed to the next
step .
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(GND CIRCUIT)
3. RECONFIRM DTC
(a) Reconnect the A21 yaw rate and acceleration sensor (airbag sensor assembly) connector.
(b) Clear the DTC .
(c) Turn the ignition switch off.
(d) Start the engine.
(e) Perform a road test.
(f) Check if the same DTC is recorded .
Result
RESULT PROCEED TO
DTC C1381 is not output A
DTC C1381 is output B
B
REPLACE AIRBAG SENSOR ASSEMBLY
A
USE SIMULATION METHOD TO CHECK
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *