Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
(b) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER
CONNECTION
CONDITION CONDITION
3 - 4
Battery voltage not applied Below 1 Ω
Battery voltage applied to
terminal 1 and 2
10 kΩ or
higher
3 - 5
Battery voltage not applied
10 kΩ or
higher
Battery voltage applied to
terminal 1 and 2
Below 1 Ω
Text in Illustration
*1 STOP Relay
NG
REPLACE STOP LIGHT CONTROL RELAY (STOP
RELAY)
7. CHECK TERMINAL VOLTAGE (STOP LIGHT POWER SOURCE TERMINAL)
(a) Measure the voltage according to the value(s) in the table
below.
Standard Voltage:
TESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
5 - Body ground Always 11 to 14 V
1 - Body ground Ignition switch ON 11 to 14 V
Text in Illustration
*a
Component without Stop Light Control Relay (STOP Relay)
(Engine Room Relay Block and Junction Block)
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *