Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

INSPECTION PROCEDURE
NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform calibration .
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
HINT:
When DTC C1425 is output together with DTC C1380, inspect and repair the trouble areas indicated by DTC
C1425 first .
PROCEDURE
1. CHECK STOP LIGHT OPERATION
(a) Check that the stop lights come on when the brake pedal is depressed and go off when the brake
pedal is released.
OK:
CONDITION ILLUMINATION CONDITION
Brake pedal depressed. On
Brake pedal released. Off
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *