Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
(a) Disconnect the skid control ECU (brake actuator assembly)
connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S1-27 (HDCS) - Body ground Always Below 1 Ω
Text in Illustration
*a
Front view of wire harness connector
(to Skid Control ECU (Brake Actuator Assembly))
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
4. RECONFIRM DTC
(a) Clear the DTC .
(b) Check if the same DTC is recorded .
Result
RESULT PROCEED TO
DTC is output A
DTC is not output B
B
USE SIMULATION METHOD TO CHECK
A
REPLACE BRAKE ACTUATOR ASSEMBLY
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *