Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
(to Skid Control ECU [Brake Actuator Assembly])
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(GND1 CIRCUIT)
4. RECONFIRM DTC
(a) Reconnect the S1 skid control ECU (brake actuator assembly) connector.
(b) Clear the DTC .
(c) Turn the ignition switch off.
(d) Start the engine.
(e) Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
(f) Check if the same DTC is recorded .
HINT:
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table
and proceed to the next step .
Result
RESULT PROCEED TO
DTC C1241 is not output A
DTC C1241 is output B
B
REPLACE BRAKE ACTUATOR ASSEMBLY
A
USE SIMULATION METHOD TO CHECK
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *