Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

NOTICE:
Never turn a solenoid ON in any manner other than described below.
(a) With the brake pedal depressed, perform the following operations.
(b) Turn the SFLH and SFLR solenoids ON simultaneously, and check that the pedal cannot be depressed
further.
NOTICE:
Do not keep the solenoid turned ON for more than 10 seconds continuously. Allow intervals of at least 20
seconds between consecutive operations.
(c) Turn the SFLH and SFLR solenoids OFF simultaneou
sly, and check that the pedal can be depressed further.
(d) Turn the motor relay ON, and check that the pedal can be depressed.
NOTICE:
Do not keep the motor relay turned ON for more than 5 seconds continuously. Allow intervals of at least 20
seconds between consecutive operations.
(e) Turn the motor relay OFF and release the brake pedal.
5. INSPECT BRAKE ACTUATOR SOLENOID (for Rear Right Wheel)
NOTICE:
Never turn a solenoid ON in any manner other than described below.
(a) With the brake pedal depressed, perform the following operations.
(b) Turn the SRRH and SRRR solenoids ON simultaneously, and check that the pedal cannot be depressed
further.
NOTICE:
Do not keep the solenoid turned ON for more than 10 seconds continuously. Allow intervals of at least 20
seconds between consecutive operations.
(c) Turn the SRRH and SRRR solenoids OFF simultaneou
sly, and check that the pedal can be depressed further.
(d) Turn the motor relay ON, and check that the pedal can be depressed.
NOTICE:
Do not keep the motor relay turned ON for more than 5 seconds continuously. Allow intervals of at least 20
seconds between consecutive operations.
(e) Turn the motor relay OFF and release the brake pedal.
6. INSPECT BRAKE ACTUATOR SOLENOID (for Rear Left Wheel)
NOTICE:
Never turn a solenoid ON in any manner other than described below.
(a) With the brake pedal depressed, perform the following operations.
(b) Turn the SRLH and SRLR solenoids ON simultaneously, and check that the pedal cannot be depressed
further.
NOTICE:
D
o not keep the solenoid turned ON for more than 10 seconds continuously. Allow intervals of at least 20
seconds between consecutive operations.
(c) Turn the SRLH and SRLR solenoids OFF simultaneously, and check that the pedal can be depressed further.
(d) Turn the motor relay ON, and check that the pedal can be depressed.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *