Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

NEXT
OK
PROCEDURE
1. PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR
(a) Perform zero point calibration of the yaw rate and acceleration sensor .
2. PERFORM TEST MODE (SIGNAL CHECK)
(a) Turn the ignition switch off.
(b) Using the Techstream, perform a Test Mode (signal check) inspection sensor check and check that all
Test Mode (signal check) inspection items change from incomplete to complete .
OK:
All Test Mode (signal check) inspection items change from incomplete to complete
HINT:
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and
proceed to the next step .
NG
GO TO STEP 3
OK
END
3. CHECK AIRBAG SENSOR ASSEMBLY INSTALLATION
(a) Turn the ignition switch off.
(b) Check that the airbag sensor assembly has been installed properly .
OK:
The sensor should be tightened to the specified torque.
The sensor is not installed in a tilted position.
NG
INSTALL AIRBAG SENSOR ASSEMBLY CORRECTLY
4. READ VALUE USING TECHSTREAM (YAW RATE AND ACCELERA
TION SENSOR)
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *