Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
TESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
Switch on (Float down) Below 1 Ω
Text in Illustration
*a
Component without harness connected
(Brake Fluid Level Warning Switch [Brake Master Cylinder Reservoir Assembly])
HINT:
I
f there is no problem after finishing the above check, adjust the brake fluid level to the MAX level.
NG
REPLACE BRAKE MASTER CYLINDER RESERVOIR
ASSEMBLY
7.
CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BRAKE
MASTER CYLINDER RESERVOIR ASSEMBLY)
(a) Disconnect the C9 combination meter assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
C9-28 (SW) - B2-1 (+) Always Below 1 Ω
B2-2 (E) - Body ground Always 10 kΩ or higher
C9-28 (SW) or B2-1 (+) - Body ground Always 10 kΩ or higher
Result
RESULT PROCEED TO
OK (for 2GR-FKS) A
OK (for 2TR-FE) B
NG C
B
GO TO STEP 10
C
REPAIR OR REPLACE HARNESS OR CONNECTOR
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *