Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
(b) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S1-25 (GND1) - Body ground Always Below 1 Ω
Text in Illustration
*a
Front view of wire harness connector
(to Skid Control ECU [Brake Actuator Assembly])
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(GND1 CIRCUIT)
6. INSPECT BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY
(a) Turn the ignition switch off.
(b) Remove the reservoir filler cap and strainer.
(c) Disconnect the A6 brake fluid level warning switch (brake master cylinder reservoir assembly)
connector.
(d) Measure the resistance according to the value(s) in the table below.
HINT:
A float is located inside the reservoir. Its position can be changed by increasing or decreasing the level of
brake fluid.
Standard Resistance:
T
ESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
1 - 2 Switch off (Float up) 10 kΩ or higher
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *