When replacing the skid control ECU (master cylinder solenoid), perform calibration .
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
As there may be malfunctions in the transfer system related to when the transfer operates in L4, check the
transfer system first.
1. CHECK CAN COMMUNICATION SYSTEM
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen
to inspect the CAN bus .
CAN Bus Check indicates no malfunctions in CAN communication.
GO TO CAN COMMUNICATION SYSTEM (HOW TO
PROCEED WITH TROUBLESHOOTING)