Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

DTC
CODE
DTC DETECTION CONDITION TROUBLE AREA
10 and 17.4 V, the following occurs 10 times in
succession.
The condition that a delay in receiving data
from the yaw rate and acceleration sensor
and steering angle sensor occurs more than
once within 5 seconds.
U0100
When either of the following is detected:
With the IG1 terminal voltage is between 10 and 17.4
V, and the vehicle speed 15 km/h (9 mph) or more,
data cannot be sent to the ECM for 2 seconds or more.
1.
The IG1 terminal voltage is between 10 and 17.4 V,
and the vehicle speed 15 km/h (9 mph) or more for 2
seconds or more.
2.
CAN communication system (Skid
control ECU to ECM)
U0114
The CAN signal from the 4 wheel drive control ECU is lost or
malfunctioning for 1.2 seconds.
CAN communication system (Skid
control ECU to 4 wheel drive
control ECU)
U0123
When either of the following is detected:
With the IG1 terminal voltage is between 10 and 17.4
V, data from the yaw rate sensor cannot be received for
1 second or more.
1.
With the IG1 terminal voltage is between 10 and 17.4
V, the following occurs 10 times in succession.
The condition that data from the yaw rate
sensor cannot be received occurs once or
more within 5 seconds.
2.
CAN communication system (Skid
control ECU to yaw rate and
acceleration sensor (airbag sensor
assembly))
U0124
When either of the following is detected:
With the IG1 terminal voltage is between 10 and 17.4
V, data from the acceleration sensor cannot be received
for 1 second or more.
1.
With the IG1 terminal voltage is between 10 and 17.4
V, the following occurs 10 times in succession.
The condition that data from the acceleration
sensor cannot be received occurs once or
more within 5 seconds.
2.
CAN communication system (Skid
control ECU to yaw rate and
acceleration sensor (airbag sensor
assembly))
U0126
When either of the following is detected:
With the IG1 terminal voltage is between 10 and 17.4
V, data from the steering angle sensor cannot be
received for 1 second or more.
1.
With the IG1 terminal voltage is between 10 and 17.4
V, the following occurs 10 times in succession.
The condition that data from the steering
angle sensor cannot be received occurs once
2.
CAN communication system (Skid
control ECU to steering angle
sensor (spiral cable with sensor
sub-assembly))
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *