Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
(a) Turn the ignition switch to the ON position.
(b) Measure the voltage.
Standard:
TESTER CONNECTION SPECIFIED CONDITION
D4-12 (TS) - D4-4 (CG) 10 to 14 V
(c) Turn the ignition switch to OFF.
NG
GO TO STEP 3
2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DL
C3)
(a) Disconnect the skid control ECU (master cylinder solenoid)
connector.
(b) Measure the resistance.
Standard:
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *