Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
Last Modified: 11-13-2015 6.6 J Doc ID: RM00000451V01VX
Model Year Start: 2016 Model: Tacoma Prod Date Range: [08/2015 - ]
Title: BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster): TRAC OFF
Indicator Light does not Come ON; 2016 MY Tacoma [08/2015 - ]
TRAC OFF Indicator Light does not Come ON
DESCRIPTION
Refer to TRAC OFF Indicator Light Remains ON .
WIRING DIAGRAM
Refer to TRAC OFF Indicator Light Remains ON .
INSPECTION PROCEDURE
NOTICE:
When replacing the skid control ECU (master cylinder solenoid), perform calibration .
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1.
CHECK CAN COMMUNICATION SYSTEM
NG
GO TO CAN COMMUNICATION SYSTEM (HOW TO
PROCEED WITH TROUBLESHOOTING)
2. INSPECT SKID CONTROL ECU (CSW TERMINAL)
(a) Disconnect the S1 skid control ECU (master cylinder solenoid) connector.
(b) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER CONNECTION SWITCH CONDITION SPECIFIED
CONDITION
S1-9 (CSW) - Body VSC OFF switch not
10 kΩ or higher
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *