Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
OK
A
REPLACE MASTER CYLINDER SOLENOID
3. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)
(a) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
D4-4 (CG) - Body ground Always Below 1 Ω
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
4. CHECK HARNESS AND CONNECTOR (ECM - DLC3)
(a) Disconnect the ECM connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
D4-13 (TC) - E14-20 (TC) Always Below 1 Ω
D4-13 (TC) - Body ground Always 10 kΩ or higher
(c) Reconnect the ECM connector.
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *