Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
PROCEDURE
1. INSPECT DLC3 (TC TERMINAL VOLTAGE)
(a) Turn the ignition switch to ON.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
TESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
D4-13 (TC) - D4-4 (CG) Ignition switch ON 11 to 14 V
(c) Turn the ignition switch off.
NG
GO TO STEP 3
2. CHECK CAN COMMUNICATION SYSTEM
(a) Check if the CAN communication DTC is output .
Result
RESULT PROCEED TO
DTC is not output A
DTC is output B
B
GO TO CAN COMMUNICATION SYSTEM (HOW TO
PROCEED WITH TROUBLESHOOTING)
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *