Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

TESTER DISPLAY TEST PART CONTROL RANGE DIAGNOSTIC NOTE
Slip Indicator Light Slip indicator light Indicator light OFF/ON
Observe the combination meter.
[Vehicle condition]
Vehicle stopped
(f) When performing the slip Warning Light Active Test, check slip indicator light in the Data List.
ABS/VSC/TRAC
TESTER DISPLAY MEASUREMENT ITEM/RANGE NORMAL CONDITION DIAGNOSTIC NOTE
Slip Indicator Light Slip indicator light/ ON or OFF
ON: Indicator light on
OFF: Indicator light off
-
Result
RESULT PROCEED TO
Slip indicator light in the Data List does not change using the Active Test A
Slip indicator light in the Data List turns ON/OFF using the Active Test B
B
GO TO STEP 3
A
REPLACE MASTER CYLINDER SOLENOID
3. INSPECT COMBINATION METER ASSEMBLY
(
a) Turn the ignition switch off.
(b) Perform Active Test of the combination meter assembly using the Techstream.
(c) Check the combination meter assembly.
OK:
The slip warning light turns on or off in accordance with the Techstream.
NG
GO TO METER / GAUGE SYSTEM
OK
REPLACE MASTER CYLINDER SOLENOID
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *