Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

Last Modified: 11-13-2015 6.6 D Doc ID: RM000001DWW034X
Model Year Start: 2016 Model: Tacoma Prod Date Range: [08/2015 - ]
Title: BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster): DTC CHECK /
CLEAR; 2016 MY Tacoma [08/2015 - ]
DTC CHECK / CLEAR
1. DTC CHECK / CLEAR (when Using Techstream)
(a) Check for DTCs.
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Enter the following menus: Chassis / ABS/VSC/ TRAC / Trouble Codes.
(5) Read the DTCs by following the prompts on the Techstream screen.
(b) Clear the DTCs.
(1) Connect the Techstream to the DLC.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Enter the following menus: Chassis / ABS/VSC/ TRAC / Trouble Codes.
(5) Operate the Techstream to clear the codes.
HINT:
R
efer to the Techstream operator's manual for further details.
2. DTC CHECK / CLEAR (when Using SST Check Wire)
(
a) Check for DTCs.
(1) Turn the ignition switch off.
(2) Using SST, connect terminals 13 (TC) and 4 (CG) of the
DLC3.
SST: 09843-18040
Text in Illustration
*a Front view of DLC3
(3) Turn the ignition switch to ON.
(4) Read the DTCs output from the ABS warning light and slip indicator light in the combination meter.
HINT:
W
hen the system is operating correctly, each light will blink continuously in a pattern of 0.25 seconds on,
then 0.25 seconds off.
When one DTC is output, each light will output the same code at 4 second intervals. (For example, Code 21
would be output as 2 flashes, a 1.5 second pause, and then 1 flash)
When 2 or more DTCs are output, each light will output a different code at 2.5 second intervals, and when
all codes have been output, there will be a 4 second pause and the sequence will repeat.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *