Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

TYPE PEDAL HEIGHT
Manual transmission 160.5 to 170.5 mm (6.319 to 6.712 in.)
NOTICE:
Do not adjust the pedal height. Doing so by changing the push rod length will structurally change the pedal
ratio.
If the pedal height is incorrect, adjust the rod operating adapter length.
(b) Adjust the rod operating adapter length.
(1) Remove the clip and clevis pin.
(2) Loosen the clevis lock nut.
(3) Adjust the rod operating adapter length by turning the pedal
push rod clevis.
Rod operating adapter length A:
for Hydraulic brake booster
214 to 224 mm (8.425 to 8.818 in.)
for Vacuum brake booster
213 to 223 mm (8.386 to 8.780 in.)
(
4) Tighten the clevis lock nut.
Torque:
26 N·m {260 kgf·cm, 19ft·lbf}
(5) Install the clip and clevis pin.
If the pedal height is incorrect even when the rod
operating adapter is adjusted, check that there is
no damage in the brake pedal, brake pedal lever,
brake pedal bracket or dash panel.
Even if there is damage, there is no problem if the
reserve distance is within the standard value.
If necessary, replace the parts.
2. INSPECT AND ADJUST STOP LIGHT SWITCH ASSEMBLY
HINT:
If the pedal height is incorrect, check and adjust the stop light switch.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *