Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
ABS/VSC/TRAC
TESTER DISPLAY TEST PART CONTROL RANGE DIAGNOSTIC NOTE
Crawl Control Light CRAWL indicator light Indicator light ON/OFF Observe the combination meter.
(f) Check the Techstream display condition of the brake warning light.
Result
RESULT PROCEED TO
Display of the Data List remains OFF A
Display of the Data List remains ON B
B
REPLACE MASTER CYLINDER SOLENOID
A
GO TO METER / GAUGE SYSTEM
4.
I
NSPECT DRIVE MONITOR SWITCH
NG
REPLACE DRIVE MONITOR SWITCH
5.
INSPECT ROOF CONSOLE BOX ASSEMBLY
B
REPLACE ROOF CONSOLE BOX ASSEMBLY
C
REPLACE ROOF CONSOLE BOX ASSEMBLY
A
REPAIR OR REPLACE HARNESS OR CONNECTOR
(MASTER CYLINDER SOLENOID - ROOF CONSOLE
BOX ASSEMBLY)
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *