Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
NG
GO TO STEP 4
3. READ VALUE USING TECHSTREAM (CRAWL CONTROL LIGHT)
(
a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
(f) According to the display on the Techstream, read the Data List.
ABS/VSC/TRAC
TESTER DISPLAY MEASUREMENT ITEM/RANGE NORMAL CONDITION DIAGNOSTIC NOTE
Crawl Control Light Crawl indicator light/ ON or OFF
ON: Indicator light on
OFF: Indicator light off
-
(g) Check the Techstream display condition of the brake warning light.
Result
RESULT PROCEED TO
Display of the Data List remains OFF A
Display of the Data List remains ON B
B
REPLACE MASTER CYLINDER SOLENOID
A
GO TO METER / GAUGE SYSTEM
4. INSPECT DRIVE MONITOR SWITCH
(a) Remove the crawl control switch (drive monitor switch) .
(b) Inspect the crawl control switch (drive monitor switch) .
NG
REPLACE DRIVE MONITOR SWITCH
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *