Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

(2) Using SST, connect terminals 12 (TS) and 4 (CG) of the
DLC3.
SST: 09843-18040
Text in Illustration
*a Front view of DLC3
(c) Push the ON/OFF switch and check that the crawl indicator light
is on while the switch is being pushed.
Text in Illustration
*a Drive Monitor Switch
*b ON/OFF Switch
*c Speed Selector Switch
(d) Turn the ON/OFF switch off.
(e) Set the target vehicle speed to L (low) with the speed selector switch.
(f) Set the target vehicle speed to medium-low with the speed selector switch.
(g) Set the target vehicle speed to M (medium) with the speed selector switch.
(h) Set the target vehicle speed to medium-high with the speed selector switch.
(i) Set the target vehicle speed to H (high) with the speed selector switch.
(j) Set the target vehicle speed to L (low) with the speed selector switch.
HINT:
T
he speed selector status is displayed on the multi-information display.
(k) Turn the ignition switch off.
(l) Check if DTC C120A is output.
HINT:
If DTC C120A is not output, calibration was performed successfully.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *