Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

While obtaining the zero point, do not vibrate the vehicle by tilting, moving or shaking it and keep it
stationary. (Do not start the engine.)
Be sure to do this on a level surface (with an inclination less than 1°).
(a) Procedures for test mode:
(1) Turn the ignition switch to off.
(2) Check that the steering wheel is in the straight- ahead position.
(3) for Automatic transmission: Check that the shift lever is in P and apply the parking brake.
for Manual transmission: Check that the shift lever is in neutral and apply the parking brake.
NOTICE:
D
TC C1210 and C1336 will be recorded if the shift lever is not in the P position.
(4) Using SST, connect terminals TS and CG of the DLC3.
SST: 09843-18040
Text in Illustration
*a Front view of DLC3
(5) Turn the ignition switch to ON.
(6) Keep the vehicle stationary on a level surface for 5 seconds or more.
(7) Check that the slip indicator light comes on for several seconds and then blinks in the test mode
pattern (0.125 seconds on and 0.125 seconds off).
HINT:
I
f the slip indicator light does not blink, perform the zero point calibration again.
The zero point calibration is performed only once after the system enters test mode.
Calibration cannot be performed again until the stored data is cleared once.
(8) Turn the ignition switch off.
6. PERFORM CRAWL CONTROL CALIBRATION (for Automatic transmission)
(a) Enter test mode (when using the Techstream).
(1) Turn the ignition switch off.
(2) Connect the Techstream to the DLC3.
(3) Turn the ignition switch to ON.
(4) Turn the Techstream on.
(5) Enter the following menus: Chassis / ABS/VSC/TRAC / Utility / Test Mode.
(b) Enter test mode (when using SST check wire).
(1) Turn the ignition switch off.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *