Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
(c) Measure the voltage according to the value(s) in the table
below.
Standard Voltage:
TESTER CONNECTION SWITCH
CONDITION
SPECIFIED
CONDITION
S32-4 (IG) - Body
ground
Ignition switch ON 11 to 14 V
S32-5 (BAT) - Body
ground
Always 11 to 14 V
Text in Illustration
*a
Front view of wire harness connector
(to Steering Angle Sensor (Spiral Cable with Sensor
Sub-assembly))
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(POWER SOURCE CIRCUIT)
3. CHECK HARNESS AND CONNECTOR (ESS TERMINAL)
(a) Turn the ignition switch off.
(b) Disconnect the S32 steering angle sensor (spiral cable with sensor sub-assembly) connector.
(c) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S32-1 (ESS) - Body ground Always Below 1 Ω
Text in Illustration
*a
Front view of wire harness connector
(to Steering Angle Sensor (Spiral Cable with Sensor
Sub-assembly))
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *