Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

2. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
(a) Install a new O-ring onto the brake master cylinder sub-assembly.
(b) Install the brake master cylinder sub-assembly with the 2 nuts
onto the brake booster.
Torque:
13 N·m {127 kgf·cm, 9ft·lbf}
(c) Using a union nut wrench, connect the 2 brake lines to the brake
master cylinder sub-assembly.
Torque:
without union nut wrench -
20 N·m {199 kgf·cm, 14ft·lbf}
with union nut wrench -
18 N·m {187 kgf·cm, 13ft·lbf}
HINT:
This torque value can be obtained by using a torque wrench with
a fulcrum length of 300 mm (11.8 in.) and a union nut wrench
with a fulcrum length of 20 mm (0.787 in.) .
This torque value is effective when the union nut wrench is
parallel to the torque wrench.
(d) Connect the brake fluid level warning switch connector to the
brake master cylinder sub-assembly.
3. INSTALL CLUTCH RESERVOIR TUBE (for Manual Transmission)
(a) Connect the clutch reservoir tube to the reservoir.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *