Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S1-3 (FR+) - Body ground Always 10 kΩ or higher
S1-17 (FR-) - S4-1 (FR-) Always Below 1 Ω
S1-17 (FR-) - Body ground Always 10 kΩ or higher
LH
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S1-18 (FL+) - S3-2 (FL+) Always Below 1 Ω
S1-18 (FL+) - Body ground Always 10 kΩ or higher
S1-4 (FL-) - S3-1 (FL-) Always Below 1 Ω
S1-4 (FL-) - Body ground Always 10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
6. INSPECT SKID CONTROL ECU (FR+, FL+ TERMINAL)
(a) Disconnect the S4 and/or S3 front speed sensor connector.
(b) Connect the S1 skid control ECU (master cylinder solenoid) connector.
(c) Measure the voltage according to the value(s) in the table
below.
Standard Voltage:
RH
TESTER CONNECTION SWITCH
CONDITION
SPECIFIED
CONDITION
S4-2 (FR+) - Body
ground
Ignition switch ON 11 to 14 V
LH
TESTER CONNECTION SWITCH
CONDITION
SPECIFIED
CONDITION
S3-2 (FL+) - Body
ground
Ignition switch ON 11 to 14 V
Text in Illustration
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *