Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
(b) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
RH
TESTER CONNECTION CONDITION SPECIFIED CONDITION
Va1-1 - S4-1 (FR-) Always Below 1 Ω
Va1-2 - S4-2 (FR+) Always Below 1 Ω
Va1-1 - Va1-2 Always 10 kΩ or higher
LH
TESTER CONNECTION CONDITION SPECIFIED CONDITION
Wa1-1 - S3-1 (FL-) Always Below 1 Ω
Wa1-2 - S3-2 (FL+) Always Below 1 Ω
Wa1-1 - Wa1-2 Always 10 kΩ or higher
Text in Illustration
*1 Skid Control Sensor Wire
*a RH
*b LH
NG
REPLACE SKID CONTROL SENSOR WIRE
5. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - FRONT SPEED SENSOR)
(a) Install the skid control sensor wire.
(b) Disconnect the S1 skid control ECU (master cylinder solenoid) connector.
(c) Disconnect the S4 and/or S3 front speed sensor connector.
(d) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
RH
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S1-3 (FR+) - S4-2 (FR+) Always Below 1 Ω
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *