Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
OK
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
13. INSPECT STOP LP CTRL RELAY
(a) Remove the STOP LP CTRL relay from the engine room relay block.
(b) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER
CONNECTION
CONDITION SPECIFIED
CONDITION
3 - 4
Battery voltage not applied Below 1 Ω
Battery voltage applied to
terminal 1 and 2
10 kΩ or higher
3 - 5
Battery voltage not applied 10 kΩ or higher
Battery voltage applied to
terminal 1 and 2
Below 1 Ω
Text in Illustration
*1 STOP LP CTRL Relay
NG
REPLACE STOP LP CTRL RELAY
14.
CHECK HARNESS AND CONNECTOR (REAR COMBINATION LIGHT ASSEMBLY, HIGH
MOUNTED STOP LIGHT ASSEMBLY - STOP LP CTRL RELAY)
(a) Disconnect the rear combination light assembly connector.
(b) Disconnect the high mounted stop light assembly connector.
(c) Remove the STOP LP CTRL relay.
(d) Measure the resistance according the value(s) in the table below.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *