Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
3 - 4
Battery voltage not applied Below 1 Ω
Battery voltage applied to terminal 1 and 2 10 kΩ or higher
3 - 5
Battery voltage not applied 10 kΩ or higher
Battery voltage applied to terminal 1 and 2 Below 1 Ω
Text in Illustration
*1 STOP LP CTRL Relay
NG
REPLACE STOP LP CTRL RELAY
8. CHECK HARNESS AND CONNECTOR (STPO TERMINAL)
(a) Disconnect the skid control ECU (master cylinder solenoid)
connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
TESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
S1-16 (STPO) - Body ground Ignition switch ON 11 to 14 V
Text in Illustration
*a
Front view of wire harness connector
(to Skid Control ECU (Master Cylinder Solenoid))
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(STPO CIRCUIT)
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *