Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
(a) Remove the STOP LP CTRL relay from the engine room relay
block.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
TESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
1 - Body ground Ignition switch ON 8 to 14 V
5 - Body ground Always 11 to 14 V
Text in Illustration
*1 Engine Room Relay Block
*2 STOP LP CTRL Relay Holder
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(STOP LP CTRL RELAY CIRCUIT)
7. INSPECT STOP LP CTRL RELAY
(a) Remove the STOP LP CTRL relay from the engine room relay
block.
(b) Measure the resistance according to the value(s) in the table below.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *