TEST PART CONTROL
Stop light control relay (STP
Observe the stop lights (does not come on for 2
to 5 seconds).
(f) Check that the stop lights turn on and off on the rear combination light when using the Techstream.
The stop lights turn on and off according to the Techstream operations.
GO TO STEP 6
5. RECONFIRM DTC
(a) Clear the DTCs .
(b) Turn the ignition switch off.
(c) Check if the same DTC is output .
RESULT PROCEED TO
DTC is output A
DTC is not output B
USE SIMULATION METHOD TO CHECK
REPLACE MASTER CYLINDER SOLENOID
6. CHECK HARNESS AND CONNECTOR (STOP LP CTRL RELAY TERMINAL)