Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
OK
OK
INSPECTION PROCEDURE
NOTICE:
When replacing the skid control ECU (master cylinder solenoid), perform calibration .
Check the speed sensor signal after cleaning or replacement .
PROCEDURE
1.
C
HECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION)
NG
GO TO STEP 9
2.
READ VALUE USING TECHSTREAM (REAR SPEED SENSOR)
NG
GO TO STEP 5
3. PERFORM TEST MODE (SIGNAL CHECK)
(
a) Perform the signal check in the Test Mode Procedure
.
OK:
All test mode DTCs are cleared.
NG
GO TO STEP 5
4. RECONFIRM DTC
(
a) Clear the DTCs
.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *