Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
OK
NOTICE:
C
heck the speed sensor signal after cleaning or replacement
.
PROCEDURE
1. CHECK REAR SPEED SENSOR INSTALLATION
(a) Turn the ignition switch off.
(b) Check the speed sensor installation.
OK:
There is no clearance between the sensor and the rear axle.
The installation nut is tightened properly.
Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)
Text in Illustration
*1 Rear Speed Sensor
*a No clearance
*b OK
*c NG
NG
INSTALL REAR SPEED SENSOR CORRECTLY
2. INSPECT REAR SPEED SENSOR TIP
(a) Remove the rear speed sensor .
(b) Check the speed sensor tip.
OK:
No scratches, oil, or foreign matter on the sensor tip.
NOTICE:
If no damage to the speed sensor tip is found during this inspection, do not replace the speed sensor.
NG
CLEAN OR REPLACE REAR SPEED SENSOR
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *