Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

Torque:
11 N·m {112 kgf·cm, 8ft·lbf}
(6) Repeat the above procedure for the other wheels to bleed the air out of the brake line.
(f) Bleed the air out of the pressure reduction line when Step 3: Decrease appears on the Techstream display.
NOTICE:
Bleed the air by following the steps displayed on the Techstream.
Make sure that the master cylinder reservoir tank does not become empty.
(1) Connect a vinyl tube to either one of the bleeder plugs.
(2) Loosen the bleeder plug (Step I).
(3) Using the Techstream, operate the brake actuator assembly, completely depress the brake pedal and
hold it there (Step J).
NOTICE:
During this procedure, the pedal will feel heavy, but completely depress it so that the brake fluid comes out
of the bleeder plug.
Hold the brake pedal depressed. Do not depress and release the pedal repeatedly.
HINT:
The operation stops automatically after 4 seconds. When performing this procedure continuously, set an
interval of at least 20 seconds.
When the operation is complete, the brake pedal goes down slightly. This is a normal phenomenon caused
when the solenoid opens.
(4) Tighten the bleeder plug, and then release the brake pedal (Step K).
(5) Repeat steps I to K until all the air in the fluid is completely bled out.
(6) Tighten the bleeder plug.
Torque:
11 N·m {112 kgf·cm, 8ft·lbf}
(7) Repeat the above procedure for the other wheels to bleed the air out of the brake line.
(g) Bleed the air out of the brake line again when Step 4: Increase appears on the Techstream display.
NOTICE:
B
leed the air by following the steps displayed on the Techstream.
Make sure that the master cylinder reservoir tank does not become empty.
(1) Connect the vinyl tube to either one of the bleeder plugs.
(2) Depress the brake pedal several times, and then loosen the
bleeder plug connected to the vinyl tube with the pedal
depressed (Step L).
(3) When fluid stops coming out, tighten the bleeder plug, and then release the brake pedal (Step M).
(4) Repeat steps L and M until all the air in the fluid is completely bled out.
(5) Tighten the bleeder plug.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *