Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

(b) Connect the Techstream to the DLC3, and turn the ignition switch ON.
NOTICE:
Do not start the engine.
(c) Select "Air Bleeding" on the Techstream.
HINT:
Refer to the Techstream operator's manual for further details.
(d) Bleed the air out of the brake line when Step 1: Increase appears on the Techstream display.
NOTICE:
B
leed the air by following the steps displayed on the Techstream.
Make sure that the master cylinder reservoir tank does not become empty.
(1) Connect the vinyl tube to either one of the bleeder plugs.
(2) Depress the brake pedal several times, and then loosen the
bleeder plug connected to the vinyl tube with the pedal
depressed (Step E).
(3) When fluid stops coming out, tighten the bleeder plug and release the brake pedal (Step F).
(4) Repeat steps E and F until all the air in the fluid is completely bled out.
(5) Tighten the bleeder plug completely.
Torque:
11 N·m {112 kgf·cm, 8ft·lbf}
(6) Repeat the above procedure for each wheel to bleed the air out of the brake line.
(e) Bleed the air out of the suction line when Step 2: Inhalation appears on the Techstream display.
NOTICE:
B
leed the air by following the steps displayed on the Techstream.
Make sure that the master cylinder reservoir tank does not become empty.
(1) Connect the vinyl tube to the bleeder plug at the right front wheel or the right rear wheel and loosen
the bleeder plug.
(2) Operate the brake actuator to bleed the air using the Techstream (Step G).
NOTICE:
Release the brake pedal at this time.
HINT:
This operation stops automatically after 4 seconds.
(3) Check if the operation has stopped by referring
to the Techstream display and tighten the bleeder plug
(Step H).
(4) Repeat steps G and H until all the air in the fluid is completely bled out.
(5) Tighten the bleeder plug.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *