Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

(c) Block the outer holes with your fingers, and release the brake
pedal (Step B).
(d) Repeat steps A and B 3 or 4 times.
(e) Using a union nut wrench, install the brake tubes into the
master cylinder.
Torque:
without union nut wrench -
20 N·m {199 kgf·cm, 14ft·lbf}
with union nut wrench -
18 N·m {187 kgf·cm, 13ft·lbf}
HINT:
This torque value can be obtained by using a torque wrench with
a fulcrum length of 300 mm (11.8 in.) and a union nut wrench
with a fulcrum length of 20 mm (0.787 in.) .
This torque value is effective when the union nut wrench is
parallel to the torque wrench.
3. BLEED BRAKE LINE
(a) Connect a vinyl tube to the bleeder plug.
(b) Depress the brake pedal several times, and then loosen the
bleeder plug with the pedal depressed (Step C).
(c) At the point where the fluid stops coming out, tighten the
bleeder plug, and then release the brake pedal (Step D).
(d) Repeat steps C and D until all the air in the fluid is completely
bled out.
(e) Tighten the bleeder plug.
Torque:
11 N·m {112 kgf·cm, 8ft·lbf}
(f) Repeat the above procedure to bleed the air out of the brake line
for each wheel.
4. BLEED BRAKE ACTUATOR
NOTICE:
A
fter bleeding the air from the brake system, if the height or feel of the brake pedal cannot be obtained,
perform air bleeding of the brake actuator with the Techstream by following the procedure below.
(a) Depress the brake pedal more than 20 times with the engine off.
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *