Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
OK
4. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BODY GROUND)
(a) Disconnect the skid control ECU (master cylinder solenoid)
connectors.
(b) Measure the resistance.
Standard Resistance:
TESTER CONNECTION SPECIFIED CONDITION
S1-1 (GND1) - Body ground Below 1 Ω
S1-32 (GND2) - Body ground Below 1 Ω
S2-4 (GND3) - Body ground Below 1 Ω
(c) Reconnect the skid control ECU (master cylinder solenoid) connectors.
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
(GND CIRCUIT)
5. RECONFIRM DTC
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *