Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
(a) Measure the resistance according to the value(s) in the table
below.
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
S1-1 (GND1) - Body ground Always Below 1 Ω
S1-32 (GND2) - Body ground Always Below 1 Ω
S2-4 (GND3) - Body ground Always Below 1 Ω
Text in Illustration
*a
Front view of wire harness connector
(to Skid Control ECU (Master Cylinder Solenoid))
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
5. RECONFIRM DTC
(a) Clear the DTCs .
(b) Turn the ignition switch off.
(c) Check if the same DTCs are output .
HINT:
Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for
DTCs.
Result
RESULT PROCEED TO
DTC is output A
DTC is not output (When troubleshooting in accordance with Diagnostic Trouble Code Chart) B
DTC is not output (When troubleshooting in accordance with Problem Symptoms Table) C
B
USE SIMULATION METHOD TO CHECK
C
PROCEED TO NEXT SUSPECTED AREA SHOWN IN
PROBLEM SYMPTOMS TABLE
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *