Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

OK
3. CHECK HARNESS AND CONNECTOR (IG1 TERMINAL)
(a) Disconnect the skid control ECU (master cylinder solenoid)
connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
TESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
S1-46 (IG1) - Body ground Ignition switch ON 11 to 14 V
Text in Illustration
*a
Front view of wire harness connector
(to Skid Control ECU (Master Cylinder Solenoid))
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
4. CHECK HARNESS AND CONNECTOR (GND TERMINAL)
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *