Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

INSPECTION PROCEDURE
NOTICE:
When replacing the skid control ECU (master cylinder solenoid), perform zero point calibration .
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1. READ VALUE USING TECHSTREAM (IG VOLTAGE)
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Start the engine.
(f) Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
ABS/VSC/TRAC
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *