Tacoma

Toyota Tacoma 2015-2018 Brake Workshop Manual

(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
TESTER CONNECTION SWITCH CONDITION SPECIFIED CONDITION
A21-21 (IG2) - Body ground Ignition switch ON 11 to 14 V
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
TESTER CONNECTION CONDITION SPECIFIED CONDITION
A21-25 (E1) - Body ground Always Below 1 Ω
A21-26 (E2) - Body ground Always Below 1 Ω
Text in Illustration
*a
Front view of wire harness connector
(to Yaw Rate and Acceleration Sensor (Airbag Sensor Assembly))
Result
RESULT PROCEED TO
OK (When troubleshooting in accordance with Diagnostic Trouble Code Chart) A
OK (When troubleshooting in accordance with Problem Symptoms Table) B
NG C
B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN
PROBLEM SYMPTOMS TABLE
C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A
REPLACE AIRBAG SENSOR ASSEMBLY
cardiagn.com

Leave a Reply

Your email address will not be published. Required fields are marked *